Initial Use; Operation; Using The Eco Function (Water Saving Effect); Maintenance And Cleaning - Miomare 307238 Montage-, Bedienungs- Und Sicherheitshinweise

so that the eccentric rod
opening on the lower end of the adjusting
screw .
12
Screw the eccentric nut
sealing ring onto the threaded flange
Insert the upper part
the corresponding hole in the tap body
Insert the lower part
the eccentric connection.
Screw both parts of the pull rod together.
Fix the lower part of the pull rod into the eccen-
tric connection by tightening the cross-head
screw.
Check that the drain set is working properly.
If necessary, adjust the position of the eccentric
connection on the lower part of the pull rod by
loosening the cross-head screw by a few turns
and tightening it again after adjusting.
After successfully installing the product, turn on
the hot and cold water supplies.

Initial use

After the first use, carefully check all connections
for leaks. In order to remove any possible impuri-
ties, the tap must be flushed before the first use.
To do this, proceed as follows:
Unscrew the aerator housing
and the aerator seal
20
in an anti-clockwise direction.
4
Open the main water supply and allow the
water to flow for two minutes to flush out any
residues.
Then screw the aerator housing
and the aerator seal
20
spout in a clockwise direction.
4

Operation

Tilt the tap lever
1
wards to regulate the strength of the water
flow.
passes into the
25
with the narrow
23
.
18
of the pull rod through
29
.
8
of the pull rod through
28
, the aerator
19
from the tap spout
21
, the aerator
19
back onto the tap
21
upwards or press it down-
Turn the tap lever
1
anti-clockwise direction to regulate the temper-
ature of the water flow:
For cold water, turn the tap lever
wise (to the right).
For hot water, turn the tap lever
(to the left).
Using the Eco function
(water saving effect)
The cartridge in this tap has an Eco function. When
you move the tap lever
resistance.
The Eco function limits the water flow to 6 l/min.
This allows you to save up to 50% more water.
Tilt the tap lever
1
resistance.
To increase the flow rate, exert slight pressure
on the tap lever
1
resistance.

Maintenance and cleaning

CAUTION! RISK OF DAMAGE! In order to
properly clean and maintain the tap, observe
the following instructions to avoid damage.
Never clean with petrol, solvents or abrasive
cleaners, or hard bristled brushes etc. This
could damage the tap surface.

Cleaning the tap

Dry off your taps with a cloth after every use in
order to prevent a build-up of limescale.
Wipe the tap clean using a damp, soft cloth
and if necessary, a mild cleaning agent.
To clean the aerator
housing in an anti-clockwise direction and
7
remove the aerator
. Clean any limescale from the aerator and
5
then screw the individual parts back together.
in either a clockwise or
anti-clock-
1
clockwise
1
, you will notice a slight
1
until you notice a slight
until you overcome the
, unscrew the aerator
6
from the aerator seal
6
GB/IE 17