Delivery Contents; Safety Instructions; Installation - Miomare IAN 307238 Montage-, Bedienungs- Und Sicherheitshinweise

Delivery contents

1 Sink unit single-lever mixer (pre-assembled) in-
cluding fastening set
2 Flexible connecting hoses 1/2
1 Allen key
1 Assembly and operating instructions

Safety instructions

KEEP ALL SAFETY INFORMATION AND
INSTRUCTIONS FOR FUTURE REFERENCE.
DANGER TO LIFE AND RISK OF
ACCIDENTS FOR INFANTS AND
CHILDREN! Never leave children
unsupervised with the packaging material. The
packaging material poses a danger of suffocation.
Children frequently underestimate the dangers.
Always keep children away from the product.
This product may be used by children aged
8 and over as well as by persons with physical,
sensory or mental impairments or lacking expe-
rience and knowledge provided that they are
supervised or instructed in the safe use of the
product and that they understand the associated
risks. Do not allow children to play with the product.
Cleaning and user maintenance must not be
performed by children without supervision.
BEWARE OF ELECTRIC SHOCK!
Any leaks or water discharge can
cause a danger to life through electric
shock. Check carefully that all connections are
watertight and ensure that all wires for electrical
devices near the sink unit are correctly and
safely installed.
If in doubt, seek specialist advice.
CAUTION! DANGER OF SCALDING!
Ensure that the hot/cold plaque is inserted in
the correct position in order to avoid accidental
scalding.
Set the tap lever to open on a cold setting and
then proceed to adjust the water temperature.
CAUTION! PROPERTY DAMAGE! Property
damage can be caused by improper installation
"
and use of the product. Installation should be
performed by a professional.
Before installation, turn off the water supply to
your living area.
During installation, make sure that all the seals
are placed correctly on the sealing surfaces.
Do not use the tap with low pressures and
small-scale tank heaters.
Only use the product if the ambient air tempe-
rature is above 0 °C.
If there is a danger of frost, cut off the water
supply and drain the tap.
Do not use the product if it displays signs of
damage or its functionality is compromised.
Any leaks or water discharge can cause con-
siderable damage to buildings and property.
Therefore check carefully that all connections
are watertight.
Before installation, familiarise yourself with all
the on-site conditions, e.g. the available water
connections and the shut-off device.
Do not carry out repairs yourself, instead hire a
professional.
Only replace defective parts with original re-
placement parts.

Installation

CAUTION! Turn off the hot and cold water
supplies before you begin the installation.
CAUTION! Do not twist the connecting hoses
and do not pull them taut.
CAUTION! Only screw on the connecting
hoses by hand. Do not use pliers or a wrench,
or else you could damage the connecting hoses.
Note: Installing the plastic triangle is optional.
If your washbasin or sink unit is the correct shape
and thickness, it is not necessary to install the
plastic triangle.
Detach the fastening nut
thread .
13
Screw the short side of the tap thread
the tap body .
18
By hand, screw both of the flexible connecting
hoses from below into both of the
1
from the tap
11
into
13
GB/MT 25