List Of Pictograms Used; Introduction; Intended Use; Parts Description - Miomare IAN 307238 Montage-, Bedienungs- Und Sicherheitshinweise

List of pictograms used

Kitchen Sink Mixer Tap

Introduction

Congratulations on the purchase of your
new product. You have chosen a high-
quality product. The assembly and oper-
ating instructions are part of this product. Please read
these assembly and operating instructions carefully
before use and observe all the information. These
instructions contain important information about in-
stallation, settings and care. Therefore we ask that
you retain these assembly and operating instructions
and pass them on to any future owner.

Intended use

The product is exclusively designed for the regulation
of hot and cold water flow and for installation on sink
units. The product is suitable for use with all pressure-
tight hot water systems such as central heating, in-
stantaneous water heaters, pressurised boilers, etc.
The product is not suitable for low pressure water
heaters such as wood or coal water heaters, oil or
gas hot water heaters or open electrical storage
heaters. If in doubt, consult a plumber or heating
specialist. Any use other than those stated above,
or any product modification is prohibited and can
result in injuries and / or product damage. Further-
more, improper use may result in life-threatening risks
and injuries. The tap is only for private use and is not
intended for medical or commercial use. The manu-
facturer is not liable for damages due to improper
use.
24 GB/MT
Read the assembly and
operating instructions!
Observe the warnings and
safety instructions!
There is a danger of
severe or fatal injuries!
Danger to life and risk of accidents
for infants and children
Warning - risk of electric shock!
Danger to life!

Parts description

Tap spout*
1
Cartridge base*
2
Cartridge*
3
Cartridge safety device*
4
Cartridge covering*
5
Hot / cold plaque*
6
Allen grub screw*
7
Tap lever*
8
Flexible connecting hoses
9
Allen key
10
Fastening nut
11
Plastic triangle
12
Tap thread
13
Washer
14
Sealing ring
15
Base ring seal
16
Base ring
17
Tap body*
18
Aerator housing*
19
Aerator*
20
Aerator seal*
21
*pre-assembled

Technical data

Connections: G 1/2"
Minimum flow pressure: 1.5 bar