List Of Pictograms Used; Introduction; Intended Use; Parts Description - Miomare IAN 291533 Montageanleitung

Introduction

List of pictograms used

Sink mixer tap
•
Introduction
Congratulations on your new sink mixer
tap! By purchasing this item, you have
chosen a high-quality product.
In the interests of readability, the sink mixer tap will
be referred to below as "the tap".
Please familiarise yourself with the tap before
using it for the first time. You should therefore read
the information below carefully and follow the
instructions for installation and use. Pay particular
attention to the safety instructions and follow these
to avoid risks. Use the tap only as described and
only for the specified applications.
Keep these instructions safe. Hand over all docu-
mentation along with the tap if you pass it on to
another person.
•

Intended use

The tap is designed solely for regulating the flow of
hot and cold water and is intended for installation
on washbasins. This tap is suitable for all pressur-
ised hot water systems such as central heating, con-
tinuous flow heaters, combination boilers, etc. It is
not suitable for low-pressure water heaters such as
wood or coal-fired boilers, oil or gas-fired boilers
or open-vented electric storage water heaters. If in
doubt, please contact a plumber or specialist.
30 GB/MT
Read the installation and
operating instructions!
Pay attention to the
warnings and safety
instructions!
Risk of accident or death
for infants and children!
Uses other than those described above or modifi-
cations to the tap are not permitted and may result
in damage to the tap. In addition, improper use
may lead to the risk of injury or death. The tap is
intended for domestic use only, and not for medical
or commercial applications. The manufacturer does
not accept any liability for damage caused by
improper use.
•

Parts description

Tap lever*
1
Hot/cold indicator*
2
Hex socket grub screw*
3
Tap outlet spout*
4
5 Aerator*
Tap body*
6
Base ring with silicone seal
7
C-type sealing washer
8
C-type metal washer
9
2× threaded bar with fixing nut
10
11 Drain stopper*
Adjusting screw*
12
Locknut*
13
Upper part of drain fitting*
14
Upper drain seal*
15
Lower drain seal*
16
17 Lower part of drain fitting*
Threaded flange
18
Wide sealing ring*
19
Hex key
20
Ball*
21
Risk of serious injury or
death!
Beware of electric shock!
Green Dot recycling
logo – Duales System
Deutschland GmbH.