Narrow sealing ring*
22
Eccentric nut*
23
24
Clamping plate*
Eccentric rod*
25
Eccentric connection*
26
2× connection hose (flexible)
27
Lower part of pull rod*
28
Upper part of pull rod*
29
Cartridge*
30
Cartridge retainer*
31
Cartridge cover*
32
*pre-assembled
•
Technical data
Connectors:
Minimum flow pres-
sure:
•
Package contents
1
Sink mixer tap including fastener set
1
Drain fitting
2
⅜" flexible connection hoses
1
Hex key
1
Installation/operating instructions
Safety instructions
■
DENT OR DEATH FOR IN-
FANTS AND CHILDREN! Children
must not play with the tap or carry out
cleaning/user maintenance without supervision.
■
Do not let children play with the packaging film
or parts of the packaging, otherwise they could
end up becoming entangled or may swallow
parts and choke.
G ⅜"
1.5 bar
RISK OF ACCI-
BEWARE OF ELECTRIC
■
SHOCK! Leaks or water discharge
can lead to a risk of death by electric
shock. Carefully check that all connections are
leak-tight and make sure that any wiring for
electrical equipment near the washbasin is
correctly and safely installed.
■
If in doubt, consult a specialist.
CAUTION! RISK OF SCALDING!
Make sure that the hot/cold indicator is fitted
in the correct position to avoid accidental
scalding.
■
When turning on the tap, use a cold lever set-
ting before adjusting the water temperature.
CAUTION! PROPERTY DAMAGE!
■
Improper installation and use of the tap may
cause damage to property. Have a specialist
perform the installation.
■
Turn off the water supply to your house before
installation.
■
During installation, make sure that all seals are
correctly positioned against the sealing surface.
■
Do not use the tap with low-pressure or small
electric storage heaters.
■
Only use the tap when the ambient temperature
is above 0 °C. Shut off the water supply and
empty the tap if there is a risk of freezing.
■
Do not use the tap if it shows signs of damage
or its functionality is affected.
■
Leaks and water discharge can lead to
significant property damage to buildings and
household goods. You should therefore careful-
ly check that all connections are leak-tight.
■
Before installation, familiarise yourself with all
site conditions such as available water connec-
tions and shut-off mechanisms.
■
Do not carry out repairs yourself; hire a special-
ist instead.
■
Only use original spare parts to replace defec-
tive parts.
Introduction
GB/MT
31