Cartridge*
35
Cartridge safety device*
36
Cartridge covering ring*
37
*pre-assembled
Technical data
Connections: G 1/2
"
Minimum flow pressure: 1.5 bar
Delivery contents
1 Bathroom tap including fastening kit
1 Drain set
2 Flexible connecting hoses 1/2
1 Allen key
1 Assembly and operating instructions
Safety instructions
KEEP ALL SAFETY INFORMATION AND
INSTRUCTIONS FOR FUTURE REFERENCE.
DANGER TO LIFE AND RISK
OF ACCIDENTS FOR INFANTS
AND CHILDREN! Do not allow
children to play with the tap or to carry out
cleaning or user maintenance unsupervised.
Do not allow children to play with the packag-
ing film or parts of the packaging, otherwise
they may become entangled in it whilst playing
or swallow parts and suffocate.
BEWARE OF ELECTRIC SHOCK!
Any leaks or water discharge can
cause danger to life through electric
shock.
Check carefully that all connections are water-
tight and that all wires for electrical devices near
the sink unit are correctly and safely installed.
If in doubt, seek specialist advice.
CAUTION! DANGER OF SCALDING!
Ensure that the hot/cold plaque is inserted in
"
the correct position in order to avoid accidental
scalding.
Set the tap lever to open on a cold setting and
then proceed to adjust the water temperature.
CAUTION! PROPERTY DAMAGE! Property
damage can be caused by improper installa-
tion and use of the tap. Installation should be
performed by a professional.
Before installation, turn off the water supply to
your living area.
During installation, make sure that all the seals
are placed correctly on the sealing surfaces.
Do not use the tap with low pressures and
small-scale tank heaters.
Only use the tap if the ambient air temperature
is above 0 °C.
If there is a danger of frost, cut off the water
supply and drain the tap.
Do not use the tap if it displays signs of damage
or its functionality is compromised.
Any leaks or water discharge can cause con-
siderable damage to buildings and property.
Therefore check carefully that all connections
are watertight.
Before installation, familiarise yourself with all
the on-site conditions, e.g. the available water
connections and the shut-off device.
Do not carry out repairs yourself, instead hire a
professional.
Only replace defective parts with original re-
placement parts.
Installation
CAUTION! Turn off the hot and cold water
supplies before you begin the installation.
CAUTION! Do not twist the connecting hoses
and do not pull them taut.
CAUTION! Only screw on the connecting
hoses by hand. Do not use pliers or a wrench,
or else you could damage the connecting hoses.
Note: For the installation you will need a slot
screwdriver and an open-end spanner
SW 10 mm.
GB/IE
15