Package Contents; Safety Instructions; Installation - Miomare NI182DISE-LIDL4 Montageanleitung

•

Package contents

1 Single-lever kitchen mixer tap
(pre-assembled) including fastener set
2 ⅜" flexible connection hoses
1 Hex key
1 Installation/operating instructions

Safety instructions

■
DENT OR DEATH FOR IN-
FANTS AND CHILDREN! Children
must not play with the tap or carry out
cleaning/user maintenance without supervision.
■
Do not let children play with the packaging film
or parts of the packaging, otherwise they could
end up becoming entangled or may swallow
parts and choke.
BEWARE OF ELECTRIC
■
SHOCK! Leaks or water discharge
can lead to a risk of death by electric
shock.Carefully check that all connections are
leak-tight and make sure that any wiring for
electrical equipment near the sink is correctly
and safely installed.
■
If in doubt, consult a specialist.


CAUTION! RISK OF SCALDING!


Make sure that the hot/cold indicator is fitted in
the correct position to avoid accidental scalding.
■
When turning on the tap, use a cold lever set-
ting before adjusting the water temperature.
CAUTION! PROPERTY DAMAGE
■
Improper installation and use of the tap may
cause damage to property.Have a specialist
perform the installation.
■
Turn off the water supply to your house before

installation.

■
During installation, make sure that all seals are
correctly positioned against the sealing surface.
■
Do not use the tap with low-pressure or small
electric storage heaters.
■
Only use the tap when the ambient temperature
is above 0 °C. Shut off the water supply and
empty the tap if there is a risk of freezing.
RISK OF ACCI-
■
Do not use the tap if it shows signs of damage
or its functionality is affected.
■
Leaks and water discharge can lead to
significant property damage to buildings and
household goods. You should therefore careful-
ly check that all connections are leak-tight.
■
Before installation, familiarise yourself with all
site conditions such as available water connec-
tions and shut-off mechanisms.
■
Do not carry out repairs yourself; hire a special-
ist instead.
■
Only use original spare parts to replace defec-
tive parts.
•
Installation
Note: Familiarise yourself with the tap before
installation by carefully reading these installation
and operating instructions, particularly the safety
instructions.
If incorrectly installed, the warranty will become
invalid – particularly with regard to consequential
damages.
■ CAUTION! Turn off the hot and cold water
supply before starting the installation.
CAUTION! Do not twist or apply tension to
■
the connection hoses (see Fig. A).
CAUTION! Only finger-tighten the connection
■
hoses. Do not use pliers or a spanner as this may
damage the connection hoses (see Fig. A).
Note: Assembling the plastic triangle is optional.
If your washbasin or sink is the right shape and
thickness, there is no need to fit the plastic triangle.
Follow these steps:
□
Unscrew the fixing nut
□
Screw the short end of the tap thread into the
tap body .
2
□
From below, screw the two flexible connection
hoses into the two corresponding hose inlets
16
in the tap body until finger-tight. Do not use any
tools to screw the connection hoses into the
tap. Make sure that the connection hoses are
straight and not pinched (see Fig. A).
□
Check that the seal in the base ring
rectly seated in the appropriate groove.
Installation
from the tap thread
15 11
is cor-
9
GB
.
7