Mig / Mag Welding - Synergy Off; Mig / Mag Welding - Synergy On - CEMONT PRECISA 200MP Bedienungs- Und Wartungsanleitung

5.1 - MIG / MAG WELDING – SYNERGY OFF
In manual mode (SYN OFF) this unit can work with self-shielding, flux
core wire. As default unit is ready for gas welding, so for welding without
gas, welding current polarity has to be changed according to the following
steps.
WARNING: ELECTRIC SHOCK CAN KILL!
ALWAYS TURN THE POWER OFF AND UNPLUG THE POWER CORD
FROM THE POWER SOURCE BEFORE CHANGING POLARITY.
For welding without gas, change the
power polarity as following:
Connect the earth cable to the
■
positive output terminal on the
front of the unit.
Connect the torch terminal
■
ring to the negative mounting
post on the voltage.
(Information sticker located
just over the wire feeding
motor on the inside of the unit).
For gas welding remember to reinitiate the default polarity setting as
following:
Connect the earth cable to the negative output terminal on the front
■
of the unit.
Connect the torch terminal ring to the positive mounting post on the
■
voltage.
NOTE: REMOVE DIFFUSER WHEN WELDING WITHOUT GAS TO
AVOID EXCESSIVE HEATING OF THE TORCH.
1
3
4
Mode Key
1
Press the mode key till the MIG/MAG welding screen is viewed on the
display.
MIG/MAG Function Setup Key
Press the setup key in MIG/MAG mode to access the parameters'
5
setup screen.
Use the right setting knob to select "SYN OFF" Mode.
7
Use the mode key to go back to the MIG/MAG main screen.
1
Refer to paragraph for the other parameters' setting.
7
Right Setting Knob
7
Use the right setting knob to adjust the welding voltage.
MIG/MAG WELDING SETUP
5
6
7
5
Material Key
4
Use the Material Key to adjust the electronic inductance value.
This setting allows to stabilize the arc by adapting it to the type of material
and to the operator's hand.
Low inductance = Cold arc, more spatters.
High inductance = Hot arc, few spatters.
Left Setting Knob
5.2 - MIG / MAG WELDING – SYNERGY ON
With the torch connected, the wire installed and the gas connection done,
earth cable to the negative output terminal on the front of the unit.
1
3
4
Mode Key
1
Press the mode key till the MIG/MAG welding screen is viewed on the
display.
MIG/MAG Function Setup Key
Press the setup key
5
setup screen.
Use the right setting knob
welding.
Use the mode key to go back to the MIG/MAG main screen.
1
Refer to paragraph for the other parameters' setting.
7
Right Setting Knob
Use the right setting knob to select the thickness of the material to be
welded.
NOTE: THICKNESS IS REFERRED TO A FILLET WELDING.
Material Key
4
Use the material key to view the synergic welding curves available on the
unit.
Turn the right setting key
desired synergic curve, suitable to the type of wire and to the gas going to
be used for welding.
To confirm your choice simply press the mode key
main screen.
11 - EN
3
Use the left setting knob to adjust the wire
speed.
5
in MIG/MAG mode to access the parameters'
to select the "SYN ON" mode for normal
7
7
or press the material key
7
1
EN
5
6
7
to choose the
4
to go back to the