Preparing For Cold Lamination; Lamination Process - UNITED OFFICE ULG 350 B1 Bedienungsanleitung Und Sicherheitshinweise

Preparing for cold lamination

IMPORTANT
► After hot laminating, allow the laminator to cool down completely before
beginning with cold lamination . Bear in mind, the rollers inside the laminator
will still be hot . This could damage the laminating pouch and the document
to be laminated!
♦ Insert the plug of the laminator into a mains power socket .
♦ Switch the appliance on by pushing the On/Off switch
The red Power indicator light
♦ Set the selector switch for hot and cold lamination
Ready indicator light
♦ Place the pouch thickness switch
(see also chapter Switching levels) .
♦ Place the document to be laminated into a laminating pouch of the appropriate
size .
NOTICE
► Ensure that all edges of the document have at least two millimetres of space
to the edges of the laminating pouch, as shown in Fig . 1 .
► Make certain that you use only one pouch for laminating . First flip it up, as
shown in Fig . 2 .
► For further information about the lamination process, please read the section

Lamination process .

Lamination process
♦ Place the pouch centrally on the small supporting surface at the pouch slot
If the size permits, the pouch should be placed with the closed side towards
the pouch slot
♦ Slide the pouch slowly and straightly into the pouch slot
♦ When you have slid the pouch several centimetres into the slot
be pulled in automatically . Release the laminating pouch as soon as you
notice it being pulled in automatically .
IMPORTANT
► Ensure there is at least 30 cm of open space in front of the laminator . Oth-
erwise, the pouch will not be ejected completely from the laminator after
lamination . This could damage the pouch .
♦ The finished and laminated pouch is ejected from the pouch ejector slot
of the laminator .
ULG 350 B1
lights up .
2
lights up .
3
at the corresponding pouch thickness
4
.
1
to the "ON" position .
5
to "COLD" . The green
6
1
.
1
it will then
1
7
GB │ IE │ 23
.
■