Incremental Weighing; Mode Selection; Changing The Measuring Unit; Switching Off - Silvercrest HG04157A Bedienungs- Und Sicherheitshinweise

Incremental weighing

Touching the button
on will change the numerical display
reading to „0". The „Tare" symbol
Now add another item to weigh onto the product.
The numerical display
the newly added item.
If you remove the item added to the product, the
numerical display
If you remove all items from the product, the LC
display will show a negative value indicated
2
by the minus symbol
Then briefly touch the button
the „Tare" symbol
Important! Be sure never to add more than 5 kg
to the weighing surface
can damage it.

Mode selection

The product has 3 different modes. One mode is used
to determine the weight. The other 2 modes are used
to determine the volume of water and milk.
Holding the button MODE
lecting function. The current mode indicator
, will be flashing 3 times.
11 12
During mode selecting function, select the desired
mode by touching the button MODE
time it is touched, the mode indicator
, will switch to the next mode listed:
12
„MODE weight" → „MODE water"
„MODE milk"
After flashing 3 times without any movement, it will
exit the mode selecting function.
34 GB/MT
/ ZERO with the product
3
from the
7
will appear.
9
will show the weight of
7
will again read „0".
7
.
10
/ ZERO
3
will disappear.
9
. Overloading the product
1
to entry mode se-
4
. After each
4
8
→

Changing the measuring unit

The product will display the weight in the official Euro-
pean measuring unit „g" (grams), as well as the tradi-
tional unit of weight „oz" (ounce, 1 oz ≈ 28.35 g) or
„lb'oz" (pound: ounce, 1lb = 16 oz ≈ 453.59 g).
When measuring the volume of water, the product
calculates it by the weight using the official European
unit of volume „ml" (millilitres) or the traditional unit of
measure fl'oz (fluid ounces, 1fl'oz ≈ 28.41 ml).
To switch the unit of measure, briefly touch the button
MODE . After each time it is touched, the unit
4
display will switch to the next unit listed:
6
, and
For mode weight
For mode water

Switching off

Holding the button
1-2 seconds will off the product. If no movement is
detected on the weighing surface
and no button is pressed, the product will auto-
matically switch off.
,
8

Troubleshooting

= Fault
, = Cause
11
= Solution
=
= The product is overloaded.
= Remove the overload.
=
= The batteries are too weak to weigh. You cannot
operate the product.
: g → oz → lb:oz
or milk : ml → fl'oz
/ ZERO for approx.
3
for 2 minute
1