Before First Use; Replacing The Battery; Operation; Weighing - Silvercrest HG04157A Bedienungs- Und Sicherheitshinweise

Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity marks
(+) and (-) on the battery / recharge-
able battery and the product.
Clean the contacts on the battery /
rechargeable battery and in the bat-
tery compartment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before first use (Fig. C)
Remove all packaging materials from the product.
Turn the product over and place it on a soft under-
lay to avoid scratching the surface. Loosen the
screw located at the cover of the battery compart-
ment on the back of the product.
5
Open the cover of the battery compartment
on the back of the product.
Pull out the insulation strip from the battery
compartment .
5
Close the cover of the battery compartment
and tighten the screw.
Replacing the battery (Fig. C)
Turn the product over and place it on a soft underlay
to avoid scratching the surface. Loosen the screw
located at the cover of the battery compartment
on the back of the product.
Open the cover of the battery compartment
on the back of the product.
Remove the used batteries, if present.
Insert two batteries type CR2032 in the battery
compartment
Note: Make sure you insert the batteries with the
correct polarity. This is indicated on the cover of
the battery compartment
Close the cover of the battery compartment
and tighten the screw.

Operation

Set the product on a solid, level and flat surface to
weigh.

Weighing

Note: Always place the object you wish to weigh
gently onto the weighing surface
ing the surface.
Briefly touch the button
the product. The LC display
plays for approx. 2 seconds.
Note: A slight touch of the button
and the button MODE
5
the product. If there is too much pressure, the
product may cause tilting.
During this time the weighing equipment on the
product is adjusting. Afterwards the numerical
5
display
7
the MODE indicator
show the last unit and mode selected.
Note: if an object (e.g. a key) is already on the
weighing surface
numerical display
Place the item you wish to weigh onto the product.
The numerical display
5
the item you are weighing.
.
5
.
5
to avoid damag-
1
/ ZERO
will show all dis-
2
is sufficient to operate
4
will read „0". The unit display
, ,
8 11
while switching on, the
1
will still read „0".
7
will show the weight of
7
5
5
to switch on
3
/ ZERO
3
and
6
will
12
GB/MT 33