Troubleshooting Guide - EINHELL RG-SA 1433 Originalbetriebsanleitung

11. Troubleshooting guide

Fault
Motor does not start
Engine performance
drops
Imprecise scarifying
result
Motor is running,
roller is not rotating
Danger! To protect the motor itis equipped with a thermal overload switch which cuts out when
overloaded and starts again automatically after a short cooling-down period.
Anl_RG-SA_1433_SPK9.indb 26 Anl_RG-SA_1433_SPK9.indb 26
GB
Possible causes
- No electricity in plug
- Cable defective
- Switch, switch/plug block defec-
tive
- Connections to motor or capacitor
disconnected
- Housing clogged
- Soil is too fi rm
- Housing clogged
- Roller badly worn
- roller worn
- Wrong working depth
- Toothed belt is torn
- 26 -
Rectifi cation
- Check line and fuse
- Check
- Have machine checked by a cus-
tomer service center
- Have machine checked by a cus-
tomer service center
- If necessary adjust working depth.
Clean housing so that the roller can
run freely
- Change working depth
- Clean housing
- Replace roller
- Replace roller
- Correct working depth
- By customer service workshop
25.04.2019 13:33:36 25.04.2019 13:33:36