Operating The Appliance - Grundig GDL 2661 X Handbuch

OPERATING THE APPLIANCE

Operation
Use high suction power if exces-
sive vapour is formed in kitchen. It
is recommended that furnace hood
suction unit is opened 5 minutes
before beginning cooking and is left
in operation during and for 15 min-
utes after cooking.
Control with levels
approximately after terminating cooking.
1 ON/OFF motor
Pressing the button, the hood turns
on at speed 1. Pressing the button
during functioning, the hood turns
OFF.
2 Speed Increase
Pressing the button the hood pass-
es from the OFF state to speed 1.
Pressing the button (hood in ON
state) the motor speed is increased
from speed 1 to intensive.
To each speed corresponds the ig-
nition of the respective led.
Speed 1 led L1
Speed 2 led L2
Speed 3 led L3
Intensive Speed led L4 (flashing)
The intensive speed is timed. The
standard timing is 5', at the end of
which the hood positions itself to
speed 2.
22
To deactivate the function before the
time expires press key 2, the hood
positions itself to speed 1, pressing
key 1 the hood will turn off.
3 ON/OFF lights
4 Speed timing
5 Function state indicator
Speed Timing
The timing of the speed is enabled
by pressing key 4, once the timing
expires the hood turns off.
The timing is subdivided as follows:
Speed 1 - 20 minutes (led L1 flash-
ing)
Speed 2 - 15 minutes (led L2 flash-
ing)
Speed 3 - 10 minutes (led L3 flash-
ing)
Intensive Speed - 5 minutes (led L4
flashing)
During the timed functioning press-
ing key 1 the hood turns off, if you
press key 2 or key 4 the hood re-
turns to the set speed.
Grease trap Signal
After 40 hours of operation the led
L5 turns on.
When such signal appears the in-
stalled grease trap needs to be
washed.
To reset the signal hold down key 1
for 3".