Maintenance And Cleaning - Grundig GDL 2661 X Handbuch

MAINTENANCE AND CLEANING

ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been con-
nected through a plug and socket,
then the plug must be removed
from the socket.
Cleaning
The cooker hood should be cleaned
regularly (at least with the same
frequency with which you carry out
maintenance of the fat filters) inter-
nally and externally. Clean using the
cloth dampened with neutral liq-
uid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the
basic cleaning recommendations of
the cooker hood and replacement
of the filters may cause fire risks.
Therefore, we recommend observ-
ing these instructions.
The manufacturer declines all re-
sponsibility for any damage to the
motor or any fire damage linked to
inappropriate maintenance or fail-
ure to observe the above safety rec-
ommendations.
Panel
Fig. 12
Dismantling:
Pull the panel down and remove it
from all the connecting points.
24
Cleaning:
The panel should be cleaned with
the same frequency as the fat fil-
ters, using a cloth soaked in neutral
liquid detergents.
Avoid the use of products containing
abrasives. DO NOT USE ALCOHOL!
Montage:
The panel should be fixed between
the connecting points placed for this
reason on the surface of the hood.
Attention! Always check that the
panel is fixed in its place well.
Grease filter
Fig. 10-13
Traps cooking grease particles.
The grease filter must be cleaned
once a month using non aggressive
detergents, either by hand or in the
dishwasher, which must be set to a
low temperature and a short cycle.
When washed in a dishwasher, the
grease filter may discolour slightly,
but this does not affect its filtering
capacity. To remove the grease fil-
ter, pull the spring release handle.