Declaration Of Conformity; Important Remarks - V2 DEV-R2 Handbuch

Description
The DEV-R2 module allows to control a load of up to 500W in
monostable, bistable and timer mode.
The small size of the container allows the module to be easily
inserted inside the switches.
• Power supply with extended range: 85 ÷ 260 Vac - 50/60 Hz
• Very low power consumption in stand-by
• 434.15 MHz radio receiver with integrated antenna
• Programmable through a button or PROTEO transmitters
• Compatible with SCREEN transmitters
• Stores up to 30 radio channels
• Two wired inputs: up and down
• Relay output with no-voltage contacts for loads of up to 500W
• Integrated button for programming operations
• Wireless programming via a remote control provided with
memory
Specifications
Power supply ______________________ 85 ÷ 260 Vac - 50/60 Hz
Consumption in stand-by ____________ 0,25 W
Maximum relay load: _______________ 5A (cosj = 1)
Operating temperature ______________ -20 ÷ +60 °C
Protection _________________________ IP10

IMPORTANT REMARKS

• Attention: for people safety it is important to follow carefully
the instructions. Keep the instructions.
• Important safety instructions for the installation.
Attention: a wrong installation can cause serious accidents.
Follow carefully the installation instructions .
• This device can be installed only from qualified persons.
• The control buttons and the connection cables shall have
insulation properties suitable for electrical installations with
operating voltage of not less than 300Vac
• In order to protect the device, the installer must provide for a
magnetotermical differential switch (separation among the
contacts: at least 3 mm), ensuring the omnipolar sectioning
from the power supply.
• The device must be installed only inside a junction box
or wall box.
• The device container does not provide any protection against
water. Thus, it should be installed only in protected
environments.
2A (cosj = 0,4)
9

DECLARATION OF CONFORMITY

V2 S.p.A. hereby declare that DEV-R2 products conform to the
essential requirements established in the following directives:
- 2004/108/CEE (EMC Directive in accordance with standards
EN 61000-6-2, EN 61000-6-3 + EN 50336)
- 2006/95/CEE (Low Voltage Directive in accordance with
standards EN 60335-1 + EN 60335-2-97)
- 99/05/CEE (Radio Directive in accordance with standard
EN 301 489-3)
Racconigi, lì 01/06/2015
V2 S.p.A. legal representative.
Giuseppe Pezzetto