K-FEE LATTENSIA + Betriebsanleitung Seite 81

Frequently asked questions
What is the purpose of the auto o ?
If the appliance is not in use, it will switch o automatically after either 5 minutes (factory setting) or after the time set by you under the „Auto o " feature
(your programming – see instructions on p. 38). This reduces the energy consumption of your K-fee® – your system capsule machine considerably: The ap-
pliance consumes considerably less power (under 0.5 W) than in operating mode. If you are absent for extended periods and at the end of each day, unplug
the unit from the power socket.
Why is the CLEAN button flashing?
After each time a beverage containing milk is prepared, we recommend rinsing the milk system using the CLEAN button. Therefore, the button lights up as
soon as your beverage is finished. As a reminder to rinse, the button begins to flash after 180 seconds.
Why is the appliance dispensing no milk?
1. Ensure that there is enough milk in the milk bottle and that the components of the milk system are all connected correctly (see p. 29
for more information)
2. If necessary, rinse the milk system by hand (see p. 27) and clean the milk system (see p. 29)
3. The appliance could be calcified. Descale the appliance in accordance with the instructions on p. 30/31.
Milk foam is unsatisfactory?
1. The quality of the milk foam may vary depending on the type of milk and its temperature. Always use fresh, cold milk (whole or semi-skimmed) from
the refrigerator.
2. Residue from cleaning agent in the milk bottle could impair the result. Rinse the milk system by pressing the CLEAN button (see p. 25) and rinse the milk
bottle and the components of the milk system again thoroughly.
3. The appliance could be calcified. Descale the appliance in accordance with the instructions on p. 30/31.
What do I need to do if there are error messages on the display?
Under no circumstances should you remedy error messages on the display yourself!
Please disconnect the appliance from the power supply immediately and try again one hour later. If the error message then continues to persist, please
contact K-fee customer care.
There is a total of 5 possible errors (please report the applicable error to K-fee® – your system customer care):
1. Heater / Thermoblock not heating
2. Temperature sensor (NTC) defect
3. Ceramic valve defect
4. PCB failure
5. Heater / Thermoblock too cold
41