Herunterladen Inhalt Inhalt Diese Seite drucken

Error Messages - K-FEE LATTENSIA + Betriebsanleitung

Kapselmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Alerts and errors
Alerts
Your new K-fee® – your system LATTENSIA + automatically recognises whether all basic requirements for maximum drinking pleasure and optimal appliance
condition are ensured at all times. If this is no longer the case in certain areas, a corresponding warning appears on the display – an easy to recognise white
exclamation mark on a red background. You must observe this and follow the system's suggested actions.
These alerts can be:
General, helpful infor-
mation – for example
if the water tank is al-
most empty. This alert
remains on the display
until you either press
any button or refill the
water tank. As such,
the system ensures that
you have not overloo-
ked the information.

Error messages

In addition to these alerts the appliance display informs you of technical er-
rors, malfunctions and faults. These clear, comprehensible messages are al-
ways accompanied by an instruction – such as disconnect the appliance from
the power supply and try again in one hour.
24
Instructions for upco-
ming operating steps:
Coffee
specialities
Please descale, clean
co ee system, clean
Coffee
milk system, replace
water filter. In such ca-
ses, the system always
Espresso
asks if you would like to
initiate the respective
Check water
level
process immediately or
later. In these cases,
you must actively make
a selection using the up
and down arrow keys.
Instructions that must
be performed immedia-
Coffee
specialities
tely because otherwise
the appliance is no lon-
Coffee
ger ready for use. These
could be fill the empty
water tank, empty the
Please descale
overfilled capsule con-
to start now
tainer or filled drip try,
or also the warning
to delay
that the appliance has
overheated and must
be switched o .
There is a total of 5 possible errors:
Error number
1. Heater / Thermoblock not heating
1
No respond
2. Temperature sensor (NTC) defect
from heater
3. Ceramic valve defect
4. PCB failure
Please unplug
appliance and try
5. Heater / Thermoblock too cold
again in one hour
If error continues
to persist please
contact hotline
Water tank is
empty
Please refill now

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis