Philips HEARTSTART FR3 Installations, Gebrauchs Und Wartungsanweisungen Seite 10

The FR3 Infant/Child Key is supplied with a
tether cable designed to secure it to an FR3
system case, if used. The tether is not required for
use of the Infant/Child Key. To use the tether,
follow these steps:
1. Insert the tether through the hole in the top
of the Infant/Child Key.
2. Thread the "winged" end of the tether (A)
through the single hole in its other end (B).
3. Straighten out the tether and tighten the loop
around the Key.
4. Insert the "winged" end of the tether into
the slot inside the Infant/Child Key
compartment in the upper lid of the case (A).
Feed the tether into the slot, then snap the Key
into the compartment (B).
A
Install Key in case.
5. For increased visibility of the Infant/Child Key, Philips recommends that
you label the Infant/Child Key compartment in the FR3 case, as
illustrated, with the appropriate language(s) from the set of decals
provided with the Key. The decal is designed to permit labeling in two
languages for situations in which the FR3 is configured for bilingual
operation.
2
B
4
5
Apply decal to case.
A
1
B
2 3
Thread tether into Key.