Inhaltsverzeichnis
Werbung
en
Cleaning the appliance
Before cleaning the appliance, pull out
the mains plug or switch off the fuse!
Wipe the door seal with clear water only
and then wipe dry thoroughly.
Clean the appliance with lukewarm water
and a little washing up liquid. The rinsing
water must not run into the light.
The rinsing water must not run through
the drainage hole into the evaporation
pan.
After cleaning: reconnect and switch on
the appliance.
Attention!
S Do not use abrasive or acidic cleaning
agents and solvents.
S Never clean the shelves or containers
in the dishwasher. The parts may warp!
S Regularly clean the condensation
channel and drainage hole, Fig. 9,
so that the condensation can flow out.
Clean the condensation channel with
cotton buds, etc.
24
Cleaning the cool fresh
space
When cleaning the appliance, all drawers
and telescopic rails can be taken out of
the cool fresh" compartment.
Drawers
Pull out drawers all the way and lift to
detach them. Fig. 0
To insert the drawers, place on the tele
scopic rails and push into the appliance.
Attach the drawers by pressing them
down.
Telescopic rails
Fig. q
Pull the release catches in the direction of
the arrow, pull the telescopic rails
forwards, lift up and remove.
When inserting the telescopic rails, first
slide them into the rear opening, then into
the lower opening and press down until
they lock into position.
Humidity filter
The humidity filter, Fig. 1/8, above the
humidity drawer can also be removed.
To do this, first remove the humidity
drawer. Then, lift humidity filter and pull
out.
Lift off the filter cover, Fig. w, and take out
the filter. Clean in lukewarm water. Leave
to dry and re assemble.
Werbung
Inhaltsverzeichnis
