Inhaltsverzeichnis
Werbung
en
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A to
16 A fuse.
If the appliance is to be operated
in a non European country, check on the
rating plate whether the indicated voltage
and current type correspond to the values
of your mains supply. The rating plate
is situated in the bottom left hand side of
the appliance. The mains connection
cable may be replaced by an electrician
only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
Switching on the
appliance
Fig. 2
Press the On/Off button 1.
Display 4 indicates the set temperature in
the refrigerator compartment. Displays 3
cold/fresh" come on.
When the door is opened, the interior light
comes on.
20
Selecting the
temperature
The set values can be changed,
see Description of control panel.
The factory has recommended and set
the following temperatures:
Refrigerator compartment
+4 °C
Cool fresh compartment:
at almost 0 °C
Perishable food should not be stored
warmer than +4 °C.
The temperature in the cool fresh"
compartment Fig. 1/B has been set to
almost 0 °C at the factory and should not
be changed if at all possible. If frost forms
on the refrigerated food, the temperature
can be increased. (See Eliminating minor
faults yourself".)
Note:
While the refrigerating unit is running,
condensation or frost forms on the rear
panel of the refrigerator and cool fresh"
compartments. This is quite normal.
It is not necessary to wipe off the
condensation or frost. The rear panel
defrosts automatically. The condensation
runs into the drainage channel Fig. 9.
and then to the refrigerating unit where
it evaporates.
Werbung
Inhaltsverzeichnis
