Replacing The Cartridge - Miomare 270065 Montage-, Bedienungs- Und Sicherheitshinweise

Non-observance of the above care advice can be expected to result in
damage to the surfaces of the product. This will inevitably invalidate
the guarantee.
A cartridge
hardness and / or degree of contamination of the water. This becomes
evident when the handle
11
Note: This step requires an open-end spanner SW 27 mm or fitting pliers.
Proceed as follows to replace the cartridge
54 GB
270065_Spueltisch-Armatur_Content_CH.indd 54
Unscrew the aerator attachment and aerator
vals and remove any limescale deposits or foreign bodies. In the
event of excessive dirt or damage replace the the aerator attach-
ment and aerator
10
Note: The aerator attachment and aerator
unscrewed by hand. Otherwise you can carefully use a pipe
wrench and you must lay a thin, damp cloth around the aerator
attachment and aerator
wrench with plastic jaws is also suitable.

Replacing the cartridge

is a wear part that needs replacing according to the
11
can be obtained from the listed service office.
Shut off the main water supply. Allow any remaining water in the
pipework to drain.
Remove the hot / cold plaque
highest position and inserting a flat object between the edge of the
hot / cold plaque
14
Note: Use light pressure to carefully push the hot / cold plaque
outward so as not to scratch the surface.
with a new one.
so that you do not damage it. A pipe
10
becomes difficult to move. A new cartridge
16
11
by adjusting the handle
14
and the outside of the handle
at regular inter-
10
can normally be
10
:
to the
16
.
16
14
13.08.15 17:32