First Use; Operation; Maintenance And Cleaning; Cleaning The Tap - Miomare NI182DISE-LIDL4 Montageanleitung

First use

□
Place the base ring onto the sink so that it sur-
rounds the tap mounting hole with the seal lying
against the sink.
□
Feed the fitted connection hoses through the
base ring and into the mounting hole, then
place the tap body on the base ring.
□
Feed the fixing nut, the washer
ring and (if required) the plastic triangle
13
over the connection hoses from below. If using
the plastic triangle, make sure that the smooth
side is facing upwards so that it lies directly
against the bottom of the sink when installed.
□
Attach the tap to the sink by finger-tightening
the fixing nut as far as it will go onto the tap
base from below.
□
Screw the connection hoses onto the angled
valves at your wall connection point. Make sure
that both the connection hoses are correctly
attached to the hot or cold water supply.
□
Once successfully installed, turn on the hot and
cold water supply.
•
First use
Make sure to carefully check that all connections
are leak-tight after the first use.
The tap must be flushed to remove any impurities
before using it for the first time.
To do this, follow the steps below:
□
Unscrew the aerator
tap outlet spout (see "Maintenance and
1
cleaning" section).
□
Turn on the main water supply and let the water
run for two minutes to remove residue.
□
Finally, screw the aerator clockwise back onto
the tap outlet spout.
•

Operation

□
Tilt the tap lever
8
wards to regulate the strength of the water flow.
□
Turn the tap lever clockwise or anticlockwise to
regulate the temperature of the water flow:
For cold water, turn the tap lever clockwise (to
the right).
For hot water, turn the tap lever anticlockwise
(to the left).
26 GB/MT
, the sealing
14
anticlockwise from the
17
forwards or push it back-
•

Maintenance and cleaning

■ CAUTION! RISK OF DAMAGE! Follow
the instructions below on properly cleaning and
maintaining the tap to avoid damage. Never
use petrol, solvents, harsh cleaning products
or hard brushes for cleaning as these could
damage the surface of the tap.
10
•

Cleaning the tap

□
Dry your taps with a cloth after every use to
prevent the build-up of limescale.
□
Wipe the tap clean with a soft, damp cloth and
a mild detergent if necessary.
□
Unscrew the aerator
spout at regular intervals and remove any
1
hard residue or foreign bodies. If the aerator is
very dirty or damaged, replace it with a new
one.
Note: You should be able to unscrew the
aerator by hand. If this is not possible, protect
the aerator by wrapping it in a thin, damp cloth
and carefully unscrew it using a pipe wrench.
•

Replacing the cartridge

Cartridges are consumable parts which must be
replaced at regular intervals depending on water
hardness and impurity levels. If the tap lever
becomes more difficult to operate, this may be a
sign that the cartridge needs to be replaced. You
can obtain replacement cartridges directly from the
specified service centre.
Follow these steps:
□
Carefully prise the hot/cold indicator
tap lever using a small flat-head screwdriver.
8
□
Loosen the hex socket grub screw
neath by using the hex key
clockwise a few times. Do not unscrew the hex
socket grub screw completely. Only loosen it far
enough to easily remove the tap lever.
□
Remove the tap lever.
□
Unscrew the cartridge cover
by hand.
□
Unscrew the cartridge retainer
with a pipe wrench.
from the tap outlet
17
out of the
6
under-
7
to turn it anti-
12
anticlockwise
5
anticlockwise
4