Start-Up - Miomare 270065 Montage-, Bedienungs- Und Sicherheitshinweise

After the initial commissioning, carefully check all connections for leaks.
To remove any possible impurities the tap must be flushed before being
used for the first time. To do this, proceed as follows:
52 GB
270065_Spueltisch-Armatur_Content_CH.indd 52
Using a slot screwdriver tighten the threaded bolt
into the fitting body
the fitting base ring
Place the fitting base seal
ring on the underside of the fitting body
3
the opening on your sink unit.
Under the sink unit, first place the plastic triangle
C-sealing washer
5
threaded bolt .
7
Now attach the fastening nut
with an open-end spanner SW 12 mm until the fitting is seated firmly
on the sink unit.
Screw the connecting hoses
Be sure to correctly attach the two connecting hoses
and hot water connections.

Start-up

Unscrew the aerator attachment and aerator
Open the main water supply and allow the water to flow for two
minutes to flush out any residues.
Screw the aerator attachment and aerator
spout .
1
and remove the fastening nut
2
to the fitting body
3
into the groove on the fitting base
4
, then the C-metal washer
to the threaded bolt
8
onto your angle valves.
9
all the way
7
. Attach
8
.
2
and place it over
2
, then the
18
onto the
6
and tighten
7
to the cold
9
from the spout
10
back onto the
10
.
1
13.08.15 17:32