Disposal - Miomare 270065 Montage-, Bedienungs- Und Sicherheitshinweise

Contact your local refuse disposal authority for more details on how to
dispose of your worn-out product.
270065_Spueltisch-Armatur_Content_CH.indd 55
Loosen the locking screw
turning it counter-clockwise.
CAUTION! Do not completely unscrew the locking screw
Only loosen this as far as is necessary to remove the handle
Remove the handle
Unscrew the cartridge covering ring
spanner. Otherwise the product could be damaged.
Loosen the cartridge locknut
open-end spanner SW 27 mm and remove the entire cartridge
from the fitting body
Insert the new cartridge into the fitting in the same manner.
Note: Be sure the seal under the cartridge
Make sure that the guides are in the corresponding holes.
Reassemble all the above parts. Tighten the cartridge lock nut
using fitting pliers or an open-end spanner SW 27 mm while simul-
taneously securing the fitting from twisting. This will achieve tightness
and ensure the handle is not difficult to move.
CAUTION! Be careful not to reverse the hot / cold water plaque
The correct position is:
left = red (hot water),
right = blue (cold water).

Disposal

The packaging is made of environmentally friendly materials,
which may be disposed of through your local recycling
facilities.
with the socket head wrench
15
.
16
, do not use pliers or a
13
below with fitting pliers or an
12
.
2
by
17
.
15
.
16
11
is correctly seated.
11
12
14
GB 55
.
13.08.15 17:32