Troubleshooting - ResMed VPAP ST Bedienungsanleitung

•
bloating
•
ear or sinus discomfort
•
eye irritation
• skin rashes.

Troubleshooting

If there is a problem, try the following suggestions. If the problem cannot be solved, contact your
equipment supplier or ResMed. Do not attempt to open the device(s).
Problem/possible cause
No display
Power is not connected.
The DC plug is partially inserted into
the back of the device or inserted too
slowly.
Insufficient air delivered from the VPAP device
Ramp time is in use.
Air filter is dirty.
Air tubing is not connected properly.
Air tubing is blocked, pinched or
punctured.
Mask and headgear are not positioned
correctly.
Incorrect air tubing selected.
Device does not start when you breathe into the mask
Breath is not deep enough to trigger
SmartStart/Stop.
2
Solution
Ensure the power cable is connected and the power outlet
(if available) is on.
Fully insert the DC plug.
Wait for air pressure to build up or change ramp time.
Replace air filter.
Check air tubing.
Unblock or free the air tubing. Check the air tubing for
punctures.
Adjust position of mask and headgear.
If you are using the SlimLine, Standard or 3m air tubing
ensure that you have the correct air tubing selected via the
menu.
Take a deep breath in and out through the mask.