Troubleshooting - ResMed AirFit P10 Handbuch

Cleaning the headgear
Weekly:
1. Handwash the headgear weekly by gently rubbing in warm
(approximately 86°F or 30°C) water using mild soap.
2. Rinse well under running water and allow to air dry out of direct
sunlight.
Reprocessing the mask between patients
The Air Mini tube, vent module and HumidX/HumidX Plus must be
discarded and replaced with new ones as they cannot be disinfected
and should not be used between other patients.
Reprocess this mask when using between patients. Cleaning,
disinfection and sterilization instructions are available on
www.resmed.com/downloads/masks. If you do not have internet
access, please contact your ResMed representative.
CAUTION
Visual criteria for product inspection: If any visible deterioration of a
system component is apparent (cracking, discoloration, tears etc),
the component should be discarded and replaced.

Troubleshooting

For troubleshooting issues with HumidX/HumidX Plus, refer to the
AirMini User Guide.
Problem/possible cause
Pillows won't seal properly, mask is uncomfortable or causes red marks
Pillows or headgear may have been
fitted incorrectly or adjusted incorrectly.
8
Solution
Check that the nasal pillows with the left (L)
and right (R) indicators are inserted correctly.
Re-fit your mask according to the fitting
instructions. Readjust the headgear to ensure
it is fitted comfortably.