Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.3. Function Transform (FUNC)
Put down the "FUNC" button when measuring the voltage. Meter
will be transformed between DC and AC range. Put FUNC button
when measuring the resistance, diode and continuity, meter will
transform among them.
4.4. Range Transform
The auto range is used when measuring the voltage and resistance.
Put down the "RAN" button if the manual range is needed. Each
time you put down, range will go upward; the minimum range is
transformed if "RAN" button is put down at the maximum range. If
the "RAN" button is put down more than two seconds, auto range is
used again.
4.5. Voltage measurements
WARNING! Do not try to measure a voltage greater than 600 V
DC/AC. You might damage your meter and expose yourself to a
severe shock hazard.
1.
Connect the black test lead to COM jack.
2.
Set the function switch at V range to be used and
test leads across the source or load under measurement.
-33-
connect
Werbung
Inhaltsverzeichnis
