Cleaning And Care; Maintenance; Adjustment Of The Quick Release Fastener; Disposal - Eufab JAKE Bedienungsanleitung

Cleaning / Maintenance / Adjustment of the quick release fastener / Disposal / Contact

Cleaning and Care

The bicycle carrier can be cleaned with a mild detergent, warm
water, and/or a soft cloth.
Remove coarse dirt and dust in advance. Do not use solvents or
similar cleaners, as these could damage the bicycle carrier.
Allow the bicycle carrier to dry by itself. Do not use a hairdryer or other
heated appliances to speed up the drying process. Clean the bicycle
carrier regularly in coastal areas and in the case of use in winter con-
ditions, to rinse off salt and prolong the life of the bicycle carrier.
In prolonged periods without use (e.g. over winter), store the bicycle
carrier in a place that is dry and protected, to prolong its life.

Maintenance

Before each trip, check the bicycle carrier for wear.
Defective metal parts and tightening straps in particular must be
replaced.
Please refer to our customer service for the replacement of parts.
Any modification of original parts and materials or the construction
of bicycle carrier can adversely affect its safety and serviceability.
The steel parts of the bicycle carrier are protected at the factory
against corrosion using a powder coating. If this paint coating is
damaged, please have the damage repaired professionally as soon
as possible.
Under normal conditions, the bicycle carrier only requires cleaning
and is otherwise maintenancefree.

Adjustment of the quick release fastener

Only perform this maintenance operation if the bicycle carrier
cannot be mounted firmly to the trailer coupling, as described in the
chapter „Mounting".
Remove the bicycle carrier from the trailer coupling as
4
described in „Dismantling".
Remove the dust cap.
4
Loosen the locking nut slightly, as shown in the illustration.
4
Screw in the setting screw one quarter of a turn.
4
Tighten the locking nut.
4
Check whether the carrier is now firmly seated on the
4
trailer coupling as described in „Mounting". If not, repeat steps
described above.
26

Disposal

Due to its lighting system, the bicycle carrier is an
electrical device.
Do not dispose of electrical appliances in household
waste! Discarded electrical and electronic
equipment must be collected separately and
recycled in an environmentally sound manner.
Contact your municipal or city government on how
to dispose of old electronic equipment.
The materials are recyclable. You are making an
important contribution to protecting our
environment through recycling, material recycling
or other forms of re-utilising old appliances!
Dispose of the bicycle rack in accordance with the
laws and conditions in your country.

Contact

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com