Using The Console; Removing The Bicycle - Elite RealAxiom Wireless Bedienungsanleitung

USING THE CONSOLE

The 4 keys on the Wireless Console enable the most
common actions to be carried out without having
to use PC keyboard. The four keys are: Enter, Tab,
Up arrow and Down arrow. These correspond to
the same keys on the PC keyboard (see the section
"USING THE CONSOLE WITHOUT THE COMPUTER"
in the Help section of the manual).
Use Tab to shift the cursor between the different
fields/buttons on the screen. Use Enter to confirm
the selection or activate the button.
The " " and " " keys have the same functions as the
corresponding keys on the keyboard, and are used to
scroll the selection options in the various lists or lists
of video races and respectively activate and deactivate
the charts while the user does a video race.
In the upper part of the console there are 3 red LED's
having different functions.
The middle LED indicates console status:
• LED turned off: the console is off.
• LED blinking: Searching for connection or Stand
Alone mode.
• LED on: console connected with USB key.
The LED on the left lights when one of the four touch
keys is pushed/tapped on. The LED on the right
blinks in proportion to the resistance level of the
roller when used in "Stand Alone" mode.

REMOVING THE BICYCLE

To remove the bicycle, proceed as follows:
• Remove the console from the handlebar.
• Keep the roller of the resistance unit away
from the tyre by screwing the handle on the unit
support plate counter clockwise (fig. 40).
• Disconnect the power supply to the roller,
removing the power adapter jack from the
up key
resistance unit.
Tab key
• If installed, remove the cadence sensor from the
bicycle. Otherwise it is possible to also remove the
Enter key
magnet from the pedal crank.
down key
• Lift the stand locking lever with one hand (Fig.
39
41), while holding the bicycle saddle without the
other so that the bicycle does not fall over.
• Lift the bicycle and move it from the stand.
• The stand can then be closed so that it takes up
less space. In this case it is advisable to remove
all the cables and put them in a dry place together
with the console and USB key (Ref. 42).
B
40
V
41
42
EN
35