Using The Realaxiom Wireless Without The Computer; Using The Realaxiom Wireless With The Computer - Elite RealAxiom Wireless Bedienungsanleitung

Then tighten the 2 cables (power output, cadence
cable) to the unit using the two supplied clamps
that prevent potential damage to the connectors
plugged in to the circuit board (see fig. 38).
USING THE REALAXIOM WIRELESS
WITHOUT THE COMPUTER
It is possible to use the RealAxiom Wireless
without a computer ("Stand Alone" mode). To
activate "Stand Alone" mode, simultaneously
push the " " and " " keys (see fig. 39) on the
Wireless Console until the right LED starts
blinking, signifying that the resistance unit can
now be manually controlled through the Wireless
Console, increasing or decreasing resistance
simply by tapping on the keys (" " and " ").
In order to use this mode it is necessary to connect
the console at least once to the Real software. To
install the software and connect the PC please
see the "Using the RealAxiom Wireless with the
computer" paragraph.
Once this has been done, a link is set up between
console and resistance unit, allowing the console
to send data to the resistance unit.
To use the console with a different trainer it is
necessary to cancel data linking the console to
the old trainer:
- hold the " " "ENTER" and "TAB" keys on the
console for 3 seconds;
- then load the software and connect the trainer
to the console, this will be enough to create a new
link between the console and the new trainer.
Every time the RealAxiom Wireless enters the
"Stand Alone" mode the resistance is set to the
minimum. It is possible to adjust resistance by
pressing the " " and " " keys on the Wireless
Console. By pushing the "
increases a nd the right LED blinks faster, while
when pushing the " " key the resistance lowers
and the LED blinks slower.
The rate at which the right LED blinks is
proportional to the resistance of the roller.
In "Stand Alone" mode the resistance of the of
RealAxiom Wireless is modified in small steps,
enabling fine adjustment. This feature allows an
almost perfect simulation of the slight differences
in slope encountered during real riding. Every
press of the key brings about a small increase/
decrease in the resistance. To increase/decrease
the resistance more, keep the key pressed until
38
obtaining required resistance level.
Note: if going to stand-alone mode when the
console is connected to the PC, the RealAxiom
Wireless programme loses the connection to the
roller and may become blocked.
USING THE REALAXIOM WIRELESS
WITH THE COMPUTER
Insert the Elite Real Software CD in the DVD-
Rom drive and follow the software installation
instructions.
To accept the default parameters (recommended)
just press the "RETURN" key on all the installation
programme windows.
The installation programme windows are shown
below:
A
EN
key the resistance
33