Assembling The Cadence Sensor; Wireless Console - Pc Connection; Unit Connection - Elite RealAxiom Wireless Bedienungsanleitung

EN
To fix the Wireless console to the handlebar of the
bicycle, just place it on the tube and secure it with
the two rubbers provided, wrapping the handlebar
tube and clamping the two rubbers on the teeth
located on the back of the console.
To fix the Wireless console to the handlebar stem,
it is necessary to use the adapter included (ref. K).
The adapter must be fixed to the console in place
of the two rubbers. Therefore remove the two
rubbers, undoing the screws fixing them to the
console. Then position the adapter in place of the
2 rubbers (see image 37) and fix it with the two
screws included (ref. Q). Insert the rubbers in the
special spaces in the adapter (see image 37) and
secure them with the two screws used to fix them.

ASSEMBLING THE CADENCE SENSOR

The RealAxiom Wireless uses an innovative "sensor-
less" system that utilizes a sophisticated calculation
based on speed to track pedal cadence.
When maintaining a high pedal cadence at low re-
32
sistance levels, there may occasionally be a slight
inaccuracy in the cadence value since it is the result
of calculation and not direct monitoring. This occurs
especially with fast pedalling and low resistance.
The cadence sensor (Ref.H) enables the number of
pushes on the pedals per minute to be counted du-
ring the race. The installation instructions are given
on the "Cadence Sensor Instructions" sheet.
36
NOTE: CAUTION: DO NOT PLUG IN THE USB ANT
KEY BEFORE INSTALLING THE REAL SOFTWARE.
Wireless Console – Pc Connection
The RealAxiom Wireless console uses radio
technology for exchanging information with the
PC. To enable the exchange of data with the PC, it
is necessary to use the USB key (ref. D). This USB
key must be inserted in one of the PC's USB ports.
ATTENTION: DO NOT INSERT THE USB KEY
IN THE COMPUTER BEFORE INSTALLING THE
REAL PROGRAMME.
The maximum connection distance between the
PC and console in optimum conditions and in
open field can be up to 10 m. This distance can
drastically decrease, depending on many factors:
obstacles, electromagnetic interference, position
of the bicycle and the key.

Unit Connection

The resistance unit has 2 connectors positioned
on the back (bicycle side) of the resistance unit:
• connector for cadence sensor.
• Connector for power jack.
If you wish to install the cadence sensor (Ref.
H), plug in the sensor to the connector on the
resistance unit.
Connect the power supply (Ref. U) to the power
37
source and connect the jack to the resistance unit.
A slight vibration indicates that the system is
positioning itself in the initial position. This can
take up to 15 seconds.
IMPORTANT: TO POWER THE ROLLER, ONLY
USE THE POWER ADAPTER SUPPLIED IN THE
REALAXIOM WIRELESS BOX.
CONNECTIONS