Fitting The Bycicle - Elite RealAxiom Wireless Bedienungsanleitung

EN
FITTING THE BICYCLE
• Lower the resistance unit completely (Ref. B),
unscrewing the bolt regulator of the resistance
unit plate (Ref. V) (Fig. 9).
• Make sure the quick release of the bicycle rear
wheel is properly fixed.
• Turn the lever (HH) to the "open" position (fig.10).
• Release the ring (EE) by unscrewing it (fig.11).
• Put the bicycle in position, inserting the left end
of the rear quick release in the left bushing
(fig.12).
28
B
9
V
30°
HH
10
EE
11
• For safer clamping of the bicycle on the stand,
make sure the lever of the quick release is
horizontal (fig.13).
• Close the lever (HH), making sure it starts
pressing the quick release inside the predefined
work area; between 30° and 45° (fig. 14 and
fig.15).
• If the lever (HH) starts pressing the quick
release in the advanced work position (fig.16),
screw the left bushing pin (FF) (fig.17) so that the
12
parallel
13
30°
HH
14
HH
45°
15