Reely Big1 Bedienungsanleitung Seite 48

To program the neutral and full throttle positions, proceed as follows:
• Switch on the transmitter, leave the throttle/brake lever in the neutral position. Set the trim for the drive function to
the centre position.
• While keeping the setup button (B) pressed, switch on
the speed controller using the slide switch (A) ("ON").
• The red LED on the speed controller will then flash and
the engine will emit beeps. Release the setup button.
If you do not release the setup button, programming
mode will be enabled after a few seconds, as described
in chapter 10. b). In this case, turn off the speed control-
ler and proceed again as described above.
• Release the throttle/brake lever on the transmitter so
that it is in the neutral position.
• If you press the setup button (B) briefly, the green LED on the speed controller will flash once briefly and you will
hear a beep. The neutral position has been saved.
Beeps are generated by a brief activation of the brushless engine. This beep can be very quiet depending
on the engine. Note the LED indication on the speed controller.
• Move the throttle/brake lever forwards on the transmitter to the full throttle position, then pull it as far as it will go in
the direction of the handle and hold it there.
Attention!
If you do not move the throttle/brake lever on the transmitter or do not move it far enough during program-
ming, the vehicle may respond to even minute movements of the throttle/brake lever on the transmitter or
become uncontrollable upon completion of programming. In this case, reprogram it.
• If you press the setup button (B) briefly, the green LED on the speed controller will flash twice briefly and you will
then hear two beeps. The full throttle position for forwards will be saved.
• Move the throttle/brake lever to the reverse full throttle position (push the lever away from the handle as far as it
will go).
• If you press the setup button (B) briefly, the green LED on the speed controller will briefly flash three times and you
will hear three beeps. The reverse full throttle position will be saved.
• Release the throttle/brake lever to return it to the neutral position. Then the green LED on the speed controller
flashes four times and four audio signals can be heard. This indicates that the speed controller has detected LiPo
drive rechargeable batteries with a total of four cells.
• The vehicle is now ready for use.
48