Techly I-ALARM-KIT002 Installationsanleitung Seite 54

FAQ
Problem
No response from keypad
The keypad cannot be
registered to the control
panel
No response from the
control panel
operating on the keypad
Cannot disarm the system
by RFID tag
The keypad cannot be set
up
The keypad cannot arm,
disarm or switch to Home
Mode
54
Cause
Low battery
The batteries' positive and
negative terminals
reversed
The keyapd is locked
No response from the
alarm panel
The keypad
registered in the control
panel
when
The keypad is installed too
far from the control panel
The RFID tags have not
been registered in the
keypad
The RFID reader is disabled
The keypad is not unlocked
The keypad
switch to Setup mode
Your user code or admin
code has not been typed
before each operation
Solution
Change the battery
Remove and insert the batteries
are again according to the instructions
in this manual
Press Arm or Home Mode on the
keypad to unlock it
Make sure the alarm panel is on
Make sure the alarm panel is in
Connection Mode
is not Register the keypad in the control
panel by following the instructions
in this manual
Install the keypad and the control
panel closer to each other
It is recommended to buy a
repeater to exten the transmission
distance
Register the RFID tag in the control
panel according to the instruction
in this manual
Enter Setup Mode and activate
the function
deactivation by RFID tag"
Refer to instructions in this
manual
does not Refer to instructions in this
manual
Type your user code or admin code
before the operation
"Enable/Disable