Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Hard Reset
Press the Connect button and the Panic button (SOS) simultaneously. Release
them after 3 beeps. Wait 10 seconds. The panel beeps twice: the system is restored
to default settings. Stored phone numbers and accessories will also be deleted.
Zone setup of Accessories
Every detector can be assigned to 4 different categories: Home Zone, Delay Zone,
Normal Zone and 24-H Zone. To assign a detector to a zone, open its case and
move its jumpers according to the drawing below:
D0
D0
D0
D0
D3
D3
D3
D3
A.
Home Mode Zone
B.
Delay Zone
C.
Normal Zone
C.
24-H Zone
Normal zone
When the system is armed, if a sensor is triggered, the siren rings out. When the
system is disarmed, sensor do not trigger an alarm.
24h zone
Regardless the system is Armed or Disarmed, sensors assigned to the 24h zone
can trigger an alarm. It is recommended to assign smoke detectors, gas detectors
and outdoor beam sensors to the 24-H zone.
Delay zone
If you want to set up the entry and exit delay functions, corresponding sensors
must be assigned to the Delay zone. Once the delay time has been set up, it will
not trigger the alarm during the delay set. Refer to the instructions "Entry and Exit
delay" on page 15 of this manual. It is recommended to assign the Door / Window
Contact to the Delay zone.
Home zone
It will not trigger system alarm when system in Home mode or disarmed, and
it will trigger the alarm when system armed. It is recommend to assign motion
detectors to the Home zone so that you can have your system armed in Home
Mode when you are home and move inside your home without triggering any
alarm.
www.techly.com
23
Werbung
Inhaltsverzeichnis
