Techly I-ALARM-KIT002 Installationsanleitung Seite 35

Wireless Door / Window Contact
Features
This Door/Window Contact can be installed on doors, windows, and any other
objects that open and close. The sensor sends a signal to the control panel when
the magnet si separated from the transmitter.
Thanks to the tamper switch, any attempt to remoce the cover of the Door/
Window Contact will trigger the alarm.
Design
LED indications
Blinks once: Blinks once: the door or windows is open and the transmitter sends
a signal to the control panel.
Blinks quickly: Low power indication: The battery must be replaces.
Register the detector in the alarm system
Press the Connection button at the back of the control panel to enter the
Connection mode. Then separate the magnet from the transmitter.
To check if the registration is complete, arm the system and separate the magnet
from the transmitter again by opening the door or window on which it is installed.
If the siren rings out, the registration is successful.
PCB Layout
LED indicator
Magnet
Transmitter
www.techly.com
AA 1.5V LR6 battery
Tamper switch
Zone setting
35