Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Usage
Open the case and remove the battery
activation strip. Self-testing will start for
30 seconds.
When the sensor is in operation, if it
is triggered more than twice within 3
Connect Button
minutes, it will switch to standby mode
to save power. If no moviment is detected
within the next 3 minutes, the sensor
goes back to working mode.
Register in the control panel
Press the connection button at the back of the control panel to enter to the
connection mode. Press the Connection button at the back of the motion sensor
or trigger the sensor (by moving in the front of it) to register the detector in the
control panel.
Installation
Avoid mounting the detector close to windows, air conditioner, heater, refreigetor,
oven, sunshine and places where the temperature changes fast or where the air
stream flows frequently.
If two detectors are isntalled in the same detection scope, adjust the location to
avoid interferences and false alarms.
Top
Fit the bracket on the wall
with screws and attach the
detector
to
the
bracket.
Adjust the bracket to change
2.2 m
the detection distance and
angle, it is recommended
to mount the detector 2.2 m
from the ground.
Ground
Bottom
The detector is more sensitive
Side view
Top view
to cross movements than
vertical movements.
www.techly.com
33
Werbung
Inhaltsverzeichnis
