Exit Delay - Techly I-ALARM-KIT002 Installationsanleitung

Settings
Enter Setup Mode
1. Press Arm ( ) or Home Mode ( ) on
the keypad to unlock it.
2. Type [admin
mode.
Default admin code: 123456
Under Setup Mode, if no operation is made for 30 seconds, the keypad will exit
the setup mode automatically. The setup mode can also be exited by pressing [ ].

Exit delay

Detectors stard detecting potential intrusions immediately after the system has
been armed. To prevent alarms when you leave your house, an exit delay can be
set up. If you have set up an exit delay, the control panel will receive the signal to
arm the system when you press the Arm key ( ) on the keypad after the time set.
1. Enter Setup Mode.
2. Type [33+delay time in
3. You head one beep: the setup is
successful.
To deactivate the Exit deay, set 0 as
delay time.
Remark
The time is set in seconds, it can be set from 0 to 255. Default setting: 0.
48
code+#] to enter Setup
seconds+#].