Techly I-ALARM-KIT002 Installationsanleitung Seite 22

Control by Phone Call
Method 1
When an alarm has been triggered, the control panel dials the pre-stored phone
numbers. When you pick up the phone, follow the voice instructions to control the
panel from distance (see instructions in the table below).
Method 2
1. Dial the telephone number of the SIM card in your control panel.
2. Enter your access code (user code), followed by "#". After each key you press on
your phone, you hear one beep of confirmation. Wait until you have heard this
beep of confirmation before pressing the next key.
3. Select the operations to control the panel (see instructions in the table below).
Note
The call will end automatically if you do not send any command within 30 seconds.
Command
Press "1"
Press "0"
Press " "
Press "6"
Press "9"
Press "#"
Note
In GSM mode, the audio monitoring is not limited in time.
22
Function
Arm the system
- Disarms the system and turns the siren off
- Stops monitoring without hanging up
- Stops the phone call function without hanging up
- Starts audio monitoring mode (not limited in time)
- Stops the built-in siren and the wireless siren (if connected
to the control panel)
Turns all sirens off
- Turns the built-in siren on (whether the siren ringing settings
is ON or OFF)
- Turns the wireless siren on (if connected to the control
panel)
- Turns all sirens off
- Exits control by phone call
- Stops call recycles