Riester ri-vital Gebrauchsanweisung Seite 27

the settings can be highlighted yellow with the ↑ ↓ menu buttons and changed with the
setup button.
to exit the menu, press the ↓ menu button until the end-Back setting is reached and
confirm the basic settings with the setup button.
6.2 settings menu
after pressing the On/Off button the main screen appears after 5 seconds, you arrive in
the settings menu by pressing the setup button.
pulse signal
activate niBp mode (adult oder neonate)
cuff pressure
exit
the „neO" setting must only be used for neonates and infants with an arm
circumference of less than 13 cm.
the permanent presetting is only used for easier operation in certain surroundings, e.g.
the inflation pressure for patients who are mostly hypertonic can be set higher from the
outset.
the settings can be highlighted yellow with the ↑ ↓ menu buttons and changed with the
setup button.
to exit the menu, press the ↓ menu button until the end-Back setting is reached and
confirm the settings with the setup button.
ri-vital
®
OPeratInG cOntrOLs / BasIc settInGs
52
i
6.3 main screen
a
B
g f
h
a) sensor pulsoximeter status display sensor crossed out or sensor with arrow /
spO2 reading Pulse bar display
B) Pulse and perfusion index display
c)
systolic blood pressure nIBP error message
d) Mean arterial blood pressure (MaP) active nIBP mode (only neonate display)
e) Diastolic blood pressure
f) Body temperature display (Only with optional predictive thermometer
g)
Pulsoximeter plethysmogram
h)
Battery charge status
i) charge indicator (is turned off when the battery is fully charged)
J) error display (only appears with error message)
ri-vital
®
OPeratInG cOntrOLs / BasIc settInGs
c
J
d
e
53