Troubleshooting - Silvercrest SPBL 10000 C3 Bedienungs- Und Sicherheitshinweise

charging process. The current battery status of the power
bank 6 is displayed during the charging process by the
display 4
seconds.
To end the charging process, disconnect the USB charging
cable from the mobile device and the power bank
power bank will switch OFF and the display
off after approx. 10 seconds.
Or simply double click with ON / OFF button
power bank and the display
NOTE:
1. If you use all the USB ports, a voltage of 5 V will output at
the outputs. The maximum output current must not exceed
3.0 A for all outputs. If all USB outputs are used, fast
charge is not possible.
2. If USB Type A output 1
another USB port is connected to another device for
charging, the fast charge to USB Type A output 1
be terminated and switched to normal charge. All devices
will now output at 5 V each.
P Troubleshooting
= Problem
= Cause
= Solution
The power bank
It may be that the power bank is not connected properly.
GB/IE 30
. The display will switch off after approx. 10
2
6
will switch off.
4
is in quick charge mode, and
is not being charged.
6 . The
4 will switch
5 . The
will
2