Charging Mobile Devices With The Power Bank; Troubleshooting - Silvercrest SPBP 4 A2 Bedienungs- Und Sicherheitshinweise

4 LEDs light up = 100 %
This is approx percentage of power bank capacity but
not actual measurement.
Charging mobile devices
with the power bank
Use provided USB type A to micro USB cable with adapter
to USB type C
reliable supplier. Connect USB Type A port to USB output
of the power bank
4
And then connect USB type A to micro USB cable with
adapter to USB type C
be charged. The charging process will start automatically.
In case if the charging process does not begin immedi-
ately, press the ON / OFF switch
charging process. The current battery status of the power
bank is shown during the charging process by the
6
LED indicator
To end the charging process, separate the USB charging
cable from the mobile device and the power bank
The LED indicator
30 seconds.

Troubleshooting

= Problem
= Cause
= Solution
The power bank
It may be that the power bank is not connected properly.
Check that it is connected.
In order to charge the power bank, a power supply with
5 V and at least 3.0 A has to be used.
or other charging cable purchased from
7
.
6
to the USB-C port to device to
7
.
2
will switch off after approx.
2
is not being charged.
6
shortly to begin the
1
.
6
GB 13