Troubleshooting - Silvercrest SPT 5200 A1 Bedienungsanleitung

♦ To end the charging procedure, disconnect the
charging cable 6 from the mobile device and
the Power Bank . The charging status LEDs 4 go
off after about 20 seconds .

Troubleshooting

The Power Bank does not charge
♦ Connection may be faulty . Check the connection .
A connected device will not charge
♦ The integrated battery is empty . Charge the battery .
♦ No connection to the device . Check the connection .
♦ Press the ON button 5 to start the charging process .
♦ The charging current of the connected device is
too low (< 30 mA) or too high (> 2,1 A) .
♦ The internal overcurrent protection may have
been triggered . Disconnect the attached device
and connect the microUSB charging port 2 to
a power source for a short while (see section
Charging the Power Bank) . Afterwards, the
Power Bank can be used again .
NOTE
► If you cannot solve the problem with the
above-mentioned solutions, please contact the
Service Hotline (see chapter entitled Service) .
SPT 5200 A1
GB │ MT │
63 ■