Checking The Battery Status; Charging Mobile Devices With The Power Bank - Silvercrest SPBL 10000 C3 Bedienungs- Und Sicherheitshinweise

WARNING! Do not connect any device to be charged to
power bank as long as the power bank is charging. Remove
the charging cable from the power bank when it is fully
charged.

Checking the battery status

You can check the battery status on the display
power bank
Briefly press the ON / OFF button
shows the approximate charge status of the internal battery
in percent for approx. 10 seconds.
Charging mobile devices with the
power bank
You can charge up to three devices at the same time using the
power bank
sum of the output current may not exceed 3 A.
Connect the USB Type A to USB Type C cable
original charging cable of the device to be charged to one
of the three USB outputs: USB Type C output
A output 1
Then connect the USB-C port of the USB Type A to USB
Type C cable
charged. The charging process will start automatically.
If your mobile device has a USB Type C input, you can
use a Type C to Type C connection cable (not included)
to connect your device's Type C input to this power bank's
USB Type C output
automatically.
In case if the charging process does not begin immediately,
press the ON / OFF button
at anytime.
6
. If all outputs are used at the same time, the
6
, or USB Type A output 2
2
to the USB-C input of the device to be
7
. The charging process will start
1
5 . The display
3
briefly to begin the
5
of the
4
4
7 or the
1 , USB Type
.
GB/IE 29