ELEKTRA MICRO CASA S1 Gebrauchsanweisung Seite 37

• Always check water level before turning the machine on, because if there is
no water the heating element could be damaged.
A) Lift cover # 1 and fill tank # 3 with cold, drinkable water.
B) To turn the machine on press the main switch # 8
(To turn it off press the same button the other way), warning light # 10 will come on.
C) Press button # 9 until a few water drops will come out of filter holder # 7; by doing
this the machine takes water from tank # 3 and fills up the boiler. Warning light # 15
will come on.
D) Wait for the machine to reach the ideal temperature for perfect output, check i n g
warning light # 15, which will come off only when optimum pressure and tempera-
ture are reached.
E) To help reaching optimum pressure, turn knob # 2 during step C to blow off for a
second and then bring the knob again in the normal/closed position.
F After choosing the filter for one or two cups (# 12 or # 11), put it in filter holder
# 7, fill it with coffee using doser # 13 and press it with press # 14.
Fill the filter until about 3 mm underneath its rim.
G) Insert filter holder # 7 in its seat. It will close tightly by turning it slightly.
H) Place one or two cups under the spouts of filter holder # 7
I) Press button # 9 which controls the pump. Coffee grinding is perfect when coffee is
delivered in drops for about 25/30 seconds.
L) When you have obtained the desired amount of coffee in the cup you must press
button # 9 again to disconnect the pump.
M) The machine is equipped with a steamer # 5 to make cappuccino, punch, hot
chocolate and tea.
N) To produce steam press steam button # 4, wait for light # 15 to come off, after
about 10 seconds, then turn knob # 2.
Let any condense run off, after which the steam will flow with force giving the
desired result. When you have finished, turn the steamer knob # 2 the other way
and press steam button # 4, bringing it into its rest position.
O) When steam production is over press button # 9 until a few water drops will
come out of filter holder # 7.
* All parts are baked with transparent glaze.
* Warning: The machine should be cleaned only with a soft and damp cloth.
* Store the packaging in a safe place.
* In case of removal or service the machine should be moved only in its original pack-
aging to avoid any accidents during transport.
DIRECTIONS FOR USE
44