Network Mode (Drobopro Fs Only) - Data Robotics DroboPro FS Bedienungsanleitung

DroboPro FS
Use this screen to rename your FS array and to set a static IP address, if
necessary. Note that the name of your FS array must be no more than
14 characters and cannot contain any special characters or spaces.
For advanced users, this screen also allows you to use jumbo frames.
Click the box at the bottom of the screen (MTU) and set the desired
size. For a general discussion of jumbo frames, you can refer to
http://en.wikipedia.org/wiki/Jumbo_frame or search the Internet for
additional information. For more detailed information on using jumbo
frames on your FS array, please visit our knowledgebase article, "Which
Data Robotics products support jumbo frames?" and related links.

Network Mode (DroboPro FS only)

Your DroboPro FS can be configured in two different modes:
Independent (default): Each network interface is configured
independently and may belong to separate network segments. One
example of when you might use your DroboPro FS in this manner is to
configure one port for your local (source) files and the second port for
an offsite (destination) location.
22