Drobo Fs Setup; Install Drobo Dashboard; Inserting Drives Into Drobo Fs - Data Robotics DroboPro FS Bedienungsanleitung

III. Drobo FS Setup

Install Drobo Dashboard

If you have not already installed Drobo Dashboard, insert the Drobo
Resource CD that came with your Drobo FS into your computer. (Make
sure it is connected to your network.) You can also download the latest
version of Drobo Dashboard at: www.drobo.com/support/updates.
From the on-screen menu, select "Install." After Drobo Dashboard is
installed, it will start automatically. Drobo Dashboard assigns "Drobo-
FS" as the default name for your Drobo FS and automatically formats
the volume when it first discovers your Drobo FS. To change the name
of your Drobo FS, see page 21.
Note: To install Drobo Dashboard, you will need to have administrative rights
on your computer.

Inserting drives into Drobo FS

Once you've chosen the number and capacities of drives to install, all
you have to do is remove the face plate of your Drobo FS by simply
pulling it off and then sliding the drives into the Data Bays. It doesn't
matter which drive goes into which Data Bay. You should note that any
pre-existing data on the drives will be erased. Be sure not to touch any
exposed hard drive circuit boards after unpacking.
First orient the drive connectors so that they are pointed towards the
Drobo FS and are at the bottom of the drive (as shown). Open the Drive
Lock by pressing it towards the left and slide the drive into the Data Bay
until you feel the connector "mate" at the rear of the Drobo FS. If the
connectors seat properly, the Drive Lock will snap behind the drive,
securing it into place.
7