Connect Drobopro Fs To Your Network; Ethernet; Connect Power - Data Robotics DroboPro FS Bedienungsanleitung

Connect DroboPro FS to your network

Ethernet

Your DroboPro FS connects to a network using one or both of the two
Ethernet ports. During the initial setup of your device, we recommend
using only one of the Ethernet connections on the back of the
DroboPro FS to connect to a router or switch. Use one of the Ethernet
cables included with the original DroboPro FS. After the initial setup,
you can configure the second Ethernet port as necessary. Your array can
be configured in either Independent mode (default) or Network Failure
Protection mode. See page 22 for further information.
Note: DroboPro FS supports gigabit (1000 Mbit/s) connections. It will auto-
negotiate the highest connection speed available to the router or switch. You
will not get optimal performance if you are using a slower connection (10/100
Mbit/s).

Connect power

Once you have connected the DroboPro FS to your network, the next
step is to connect it to an AC power source. Simply connect the power
cord to the back of the DroboPro FS and to your power source. Then
press the toggle power button on the back of the unit to turn the unit
on.
Note: As with all electronic equipment, we recommend connecting your
DroboPro FS to a surge protector or uninterruptible power supply (UPS),
designed for electronics.
12