Initialize Your Drobo Fs - Data Robotics DroboPro FS Bedienungsanleitung

Note: As with all electronic equipment, we recommend connecting your
Drobo FS to a surge protector or uninterruptible power supply (UPS), designed
for electronics.

Initialize your Drobo FS

Your Drobo FS is set to automatically obtain an IP address (DHCP) on
your network. When you connect Drobo FS to the network, Drobo
Dashboard will automatically discover it. After Drobo Dashboard
discovers your Drobo FS, you can set a static IP address if desired. If you
don't have DCHP and need to use a static IP address, you should directly
connect the Drobo FS to your computer's Ethernet connection for the
initial setup. See the section, "Tips and Troubleshooting" on page 34 for
further information on direct-connect and setting the IP address of your
Drobo FS.
After you do the initial setup of your Drobo FS, you should set the
administrative username and password. You are required to do this
before you can set up shares, users, etc. Drobo Dashboard will prompt
you for share names, usernames, etc. Please see page 24 for further
information on managing shares.
9