For Your Safety; Turning The Sauna Interior Lighting On / Off; Operation - Sentiotec A2-15 Montage- Und Gebrauchsanweisung

1

For your safety

CAUTION - Damages of device:
Do not pour water on the sauna control or clean it with
a very wet cloth.
For cleaning please use a cleaning cloth, which has
been slightly moistened with a mild soapy solvent
(dish detergent).
WARNING - Fire hazard:
Prior to turning on the sauna control and when
selecting the start-time (time until the stove
starts) make sure that no combustible objects
have been placed on top of the stove.
2 Turning the sauna interior lighting
on / off
1. Key 1 turns sauna interior lighting ON / OFF.
24
Operating instructions for the user - Figure 5
3

Operation

3.1 Operation without selected time
1. Press ON / OFF 2 key
The display 4 indicates 00.00 (Display blinks)
The signal lamp 5 OPERATION lights up.
2. Press START / STOP 8 key.
The sauna heater starts.
The signal lamp 3 HEATING lights up.
Depending on the device type the display 4 indi-
cates 00.00 or the temperature measured in the
area of the temperature sensor.
3. Set the desired temperature with the rotary knob
TEMPERATURE 6 in the range of
50 - 125 degrees Celsius.
4. To exit:
4.1 Press START / STOP 8 key.
The sauna heater turns off.
The display indicates 00.00 (Display blinks)
The signal lamp 3 HEATING goes out.
The control is ready for entering a selected time
or a restart.
4.2 Press ON / OFF 2 key.
The sauna control is turned off.
3.2 Operation with selected time
1. Press ON / OFF 2 key
The display 4 indicates 00.00 (Display blinks)
The signal lamp 5 OPERATION lights up.
NOTE - „High-Speed Run":
Pressing and holding the PLUS / MINUS keys 7 trigger
a „high-speed run" entry after 5 seconds.